Model: D150 Engine: 150 HP diesel, turbo charged, intercooled, direct injected Drive: 250 mm (10 inches) diameter stainless steel water jet Coupling: Toothed Kevlar® drive belt system Cooling: Fresh water closed system w/stainless steel heat exchanger. Closed Loop Cooling Technology™ Intercooling: Seawater to air stainless steel intercooler Bollard Pull: 1,200 lbs + static pull Boat Dead Rise: Accommodates boat dead rise from 5 to 24 degrees Buoyancy: Depends on boat dead rise and weight (generally 250 to 500 lbs) Width: 40 inches (102 cm) Height: 37 inches (94 cm) Length: 46 inches (117 cm) plus mounting brackets Dry Weight: 850 lbs (387 kg) Battery: Heavy duty 12 VDC, minimum 850 marine amps, not included Alternator: 55 Ampere, 12 VDC, included Shell: FRP, high density core in impact areas, foam core in other areas, closed cell foam injected for floatation Throttle/ Shift Controls: Single or dual lever controls, up to 25 feet of 33C (throttle) and 25 feet of 43 C (shift) cables included, plan for approximately 3 feet more than would be required for a typical outboard installation Engine Gauges: Gauges included, voltmeter, tachometer with hour meter, water temp, oil pressure, warning lights, buzzer Electrical Harness: Included with instruments Battery Switch: minimum 850 amps, not included Helm: Standard outboard helm, up to 25 foot steering cable included, plan for approximately 3 feet more than a typical outboard installation Mounting System Included